Chevrolet 2016 SS Sedan Owner's Manual page 324

If the tire pressure has not
dropped more than 68 kPa
(10 psi) from the recommended
inflation pressure, inflate the
tire to the recommended
inflation pressure.
21. Wipe off any sealant from the
wheel, tire or vehicle.
22. Dispose of the used tire
sealant canister (3) and
sealant/air hose (5) assembly
at a local dealer or in
accordance with local state
codes and practices.
23. Replace it with a new canister
available from your dealer.
24. After temporarily sealing a tire
using the tire sealant and
compressor kit, take the
vehicle to an authorized dealer
within 161 km (100 mi) of
driving to have the tire repaired
or replaced.
Using the Tire Sealant and
Compressor Kit without Sealant to
Inflate a Tire (Not Punctured)
To use the air compressor to inflate
a tire with air only and not sealant:
1. On/Off Switch
2. Pressure Gauge
3. Tire Sealant Canister
4. Air Only Hose
5. Sealant/Air Hose
6. Power Plug
If a tire goes flat, avoid further tire
and wheel damage by driving slowly
to a level place. Turn on the hazard
warning flashers. See Hazard
Warning Flashers 0 124 .
ii
Vehicle Care
See If a Tire Goes Flat 0 318
other important safety warnings.
1. Remove the tire sealant and
compressor kit from its storage
location. See Storing the Tire
Sealant and Compressor Kit
0 325 .
ii
2. Lift the lever and pull the air
only hose (4) from the bottom
of the tire sealant and
compressor kit.
3. Remove the power plug (6)
from the air compressor.
4. Place the kit on the ground.
Make sure the tire valve stem
is positioned close to the
ground so the hose will
reach it.
5. Remove the tire valve stem
cap by turning it
counterclockwise.
6. Attach the air only hose (4)
onto the tire valve stem and
press the lever down to
secure it.
323
for
ii