Advertisement
How to Set ADSL Alarm Profile
Users can use the following command to change the ADSL Alarm profile for specified DSL port. The
commands are listed as below.
Command
$modify adsl line intf ifname dsl-* disable
$modify adsl alarm profile ifname dsl-*
$modify adsl line intf ifname dsl-* enable
How to Change VPI/VCI for Existing VCC
Users can use the following command to change VPI/VCI for existing VCC. The commands are listed as
below.
Command
$modify atm vc intf ifname aal5-* disable
$modify atm vc intf ifname aal5-* vpi
<new-vpi> vci <new-vci>
$modify atm vc intf ifname aal5-* enable
How to Change Management IP Address for Existing Ethernet
Port
Users can use the following command to change management IP address for existing Ethernet port. The
commands are listed as below.
Command
$modify aggr intf ifname aggr-0 ip <new-ip>
mask <new-mask>
$modify ethernet intf ifname eth-* ip
<new-ip> mask <new-mask>
How to Create more VC/EOA/Bridge
Users can use the following command to create more VC/EOA/Bridge. The commands are listed as below.
Command
$create atm vc intf ifname aal5-* vpi <vpi>
vci <vci> lowif atm-* [vcmux/llcmux]
[fast/interleaved]
$create eoa intf ifname eoa-* lowif aal5-*
$create bridge port intf portid
<bridge-port-id> ifname eoa-*
D-Link Confidential
Description
Disable
(*: 0 ~ 23)
? (*: 0 ~ 23, ?: means to get more information)
Enable
(*: 0 ~ 23)
Description
Disable
(*: Existing aal5 interface)
(*: Existing aal5 interface)
Enable
(*: Existing aal5 interface)
Description
Aggregation Ethernet
Non-Aggregation Ethernet
(*: 0 or 1)
Description
(*:0 ~ 23 is used for atm; 0~191 is used for aal5)
(*:0~191 is used for aal5 and eoa)
(*:0~191 is used for eoa,; 1~192 is used for
<bridge-port-id>)
7
Advertisement
