Advertisement
subruleid 1 srcportfrom 137 srcportto 139
srcportcmp inrange
$modify filter rule entry ruleid <id2>
status enable
$create filter rule map ifname all ruleid
<id2> stageid 1
How to Enable Spanning Tree Protocol
Users can use the following command to enable spanning tree protocol. The commands are listed as below.
Command
$modify stp info enable
$modify stp port info portid
<bridge-port-id> enable
$get stp port info portid <bridge-port-id>
How to Enable IGMP Snooping
Users can use the following command to enable IGMP snooping. The commands are listed as below. Be
aware that IGMP Snooping is the Factory Default Setting.
Command
$create filter rule entry ruleid <id>
action sendtocontrol description IGMP
$create filter subrule ip ruleid <id>
subruleid 1 prototypefrom 2 prototypecmp
eq
$modify filter rule entry ruleid <id>
status enable
$create filter rule map ifname all ruleid
<id> stageid 1
$modify igmpsnoop cfg info status enable
$modify igmpsnoop port info portid
<bridge-port-id> status enable leavemode
fastNormal
or
$modify igmpsnoop port info portid
<bridge-port-id> status enable leavemode
Fast
How to Upgrade Control Plane Code Remotely
Users can use the following command to remotely upgrade control plane code. Make sure you have prepared
TFTP server, vendor supplied CP.bin.gz , and put CP.bin.gz into root directory of TFTP server. The
commands are listed as below.
Command
D-Link Confidential
Description
Enable STP globally
Bridge port id: 1~193
Description
The feature is enabled in default.
Description
10
Advertisement
