Change The Travel Latch Position - Norcold N41 Series Installation Manual

- Put the travel latch plate on the other side of the door.
- Attach the travel latch plate with the screw.
- Put the filler plate on the other side of the door.
- Attach the filler plate with the screw.
4. Install the door:
- Put the door down onto the lower hinge pin.
- Align the holes in the upper hinge and the filler plate and hold in this position.
- Screw the upper hinge pin down into the upper hinge and into the door.
- Tighten all of the screws.
- Make sure the travel latch fully engages the travel latch plate.
- The travel latch should engage the travel latch plate .2 inches.
- If not, loosen the screws and adjust the height of the travel latch.
- Tighten the screws.

Change the travel latch position:

This refrigerator allows you to put the travel latch either at the top
of the door or at the bottom of the door regardless of the door
swing direction (See Art01570 and Art01572).
1. Change the position of the travel latch plate:
- Remove the screw [41] from the travel latch plate [162] on the
door.
- Remove the screw [41] from the filler plate [163] on the
oposite end of the door.
- Put the travel latch plate on the opposite end of the door.
- Attach the travel latch plate with the screw.
- Put the filler plate on the opposite end of the door.
- Attach the filler plate with the screw.
2. Change the position of the travel latch:
- Remove the screws from the travel latch [161].
- Put the travel latch on the opposite end of the refrigerator.
- Attach the travel latch with the screws.
163
41
162
163
41
Art01570
41
162
Art01571
161
Art01572
Installation Manual 9