Installation Options; Install The Decorative Door Panel; Reverse The Door Swing - Norcold N41 Series Installation Manual

Installation Options

Install the decorative door panel:

NOTICE
The decorative panels must be 3/16 inch or less in thickness.
- For N41X models, make a decorative door panel [38] that is 31 inches high x 21
5/16 inches wide (See Art00977).
- For N51X models, make a decorative door panel [38] that is 37 inches high x 21
5/16 inches wide (See Art00977).
- Push the decorative door panel into the slots [157] of the door end caps [158].
- Push each panel retainer [37] into the slot on the edge of the door [39].

Reverse the door swing:

This refrigerator has hinges that allow you to change the direction that the door opens
by moving the hinges to the opposite corner (See Art01313).
1. Remove the door:
- Turn out and save the upper hinge pin [63].
- Open the door a small amount and pull the top of the door away from the upper
hinge of the refrigerator.
- Lift the door off of the lower hinge pin [64].
- Turn out and save the lower hinge pin.
2. Change the position of the hinges:
- Remove the screws from the upper hinge [159].
- Put this hinge on the other side as the lower hinge.
- Attach the hinge with the screws.
- Turn the lower hinge pin down into this hinge.
- Remove the screws from the lower hinge [160].
- Remove the screws from the travel latch [161].
- Put this hinge on the other side as the upper hinge.
- Attach the hinge with the screws.
3. Change the position of the travel latch (See Art01313 and Art01571):
- Put the travel latch on the other side of the refrigerator.
- Attach the travel latch with the screws.
- Remove the screw [41] from the travel latch plate [162] on the door.
- Remove the screw [41] from the filler plate [163] on the door.
Installation Manual 8
157
37
38
159
Art01313
158
Art00977
161
63
160
64