Installation Options; Install The Decorative Door Panel; Reverse The Door Swing; Change The Travel Latch Position - Norcold N400 Installation Manual

Installation Options

Install the decorative door panel:

NOTE: The decorative panels must be 3/16 inch or less in
thickness.
- For N400 models, make a decorative door panel [1] that is
31 inches high x 21 5/16 inches wide (See Art00977).
- For N510 models, make a decorative door panel [1] that is
37 inches high x 21 5/16 inches wide (See Art00977).
- Push the decorative door panel into the slots [4] of the door
end caps [2].
- Push each panel retainer [3] into the slot on the edge of the
door.

Reverse the door swing:

This refrigerator has hinges that allow you to change the
direction that the door opens by moving the hinges to the
opposite corner (See Art01313).
1. Remove the door:
- Turn out and save the upper hinge pin [1].
- Open the door a small amount and pull the top of the door
away from the upper hinge of the refrigerator.
- Lift the door off of the lower hinge pin [2].
- Turn out and save the lower hinge pin.
2. Change the position of the hinges:
- Remove the screws from the upper hinge [3].
- Put this hinge on the other side as the lower hinge.
- Attach the hinge with the screws.
- Turn the lower hinge pin down into this hinge.
- Remove the screws from the lower hinge [4].
- Remove the screws from the travel latch [5].
- Put this hinge on the other side as the upper hinge.
- Attach the hinge with the screws.
3. Change the position of the travel latch (See Art01313 and
Art01571):
- Put the travel latch on the other side of the refrigerator.
Installation Manual 6
- Attach the travel latch with the screws.
- Remove the screw [6] from the travel latch plate [7] on the
door.
- Remove the screw [6] from the filler plate [8] on the door.
- Put the travel latch plate on the other side of the door.
- Attach the travel latch plate with the screw.
- Put the filler plate on the other side of the door.
- Attach the filler plate with the screw.
4. Install the door:
- Put the door down onto the lower hinge pin.
- Align the holes in the upper hinge and the filler plate and
hold in this position.
- Screw the upper hinge pin down into the upper hinge and
into the door.
- Tighten all of the screws.
- Make sure the travel latch fully engages the travel latch
plate.
- The travel latch should engage the travel latch plate .2
inches.
- If not, loosen the screws and adjust the height of the
travel latch.
- Tighten the screws.

Change the travel latch position:

This refrigerator allows you to put the travel latch either at the
top of the door or at the bottom of the door regardless of the
door swing direction (See Art01570 and Art01572).
1. Change the position of the travel latch plate:
- Remove the screw [6] from the travel latch plate [7] on the
door.
- Remove the screw [6] from the filler plate [8] on the oposite
end of the door.
- Put the travel latch plate on the opposite end of the door.
- Attach the travel latch plate with the screw.
- Put the filler plate on the opposite end of the door.
- Attach the filler plate with the screw.