Ibanez Prestige Series User Manual page 52

Stud lock (Edge-Zero tremolo bridge)
The Edge-Zero tremolo bridge is equipped with a stud lock
function.
1.
Insert an Allen wrench (2 mm) through the hole at the top
of the stud bolt.
2.
Turning the stud lock bolt clockwise, tighten it until the
stud lock bolt contacts the anchor nut and will no longer
rotate.
※
To release the stud lock, loosen the stud lock bolt.
Adjusting the action
To adjust the height of the entire tremolo unit, use an Allen
wrench (3 mm) to turn the stud bolts located at the left and right
of the tremolo unit. (It is not possible to make adjustments for
each string individually.)
Memo
• Make sure that the stud lock is released before you adjust the
action.
Adjusting the intonation
1.
Remove the intonation adjustment bolts stored inside
the tremolo unit, and screw them into the adjustment
holes at the back of the saddle until the tip of each bolt
contacts the wall of the tremolo unit.
2.
Use an Allen wrench (2 mm) to loosen the saddle lock bolt,
and turn the intonation adjustment bolt to adjust the saddle
position.
※
Before checking the intonation, fi rmly tighten the saddle lock
bolts and tune the guitar correctly. Before tuning, use an Allen
wrench (3 mm) to loosen the pressure pad bolts of the locking
nut. When you've fi nished making adjustments, tighten the
saddle lock bolts and the pressure pad bolts of the locking nut,
and store the intonation adjustment bolts inside the tremolo
unit.
Edge-Zero
Edge-Zero ZR-2
Edge-Zero ZR-2
EN
53
➤➤