ReliOn Micro User Instruction Manual page 53

Step 3:
Remove the cap from the control
solution bottle. While the Apply Blood symbol
, place a very small drop on
is flashing
the end of the test strip. The test strip will
draw up the solution and the meter will beep.
DO NOT put control solution on top of
the test strip.
down.
Step 4:
In 7 seconds the meter will beep
again and display the control solution result.
Compare the result to the range printed
on the test strip bottle.
is within the acceptable range. If the result
falls within this range, the meter and test strip
are working correctly.
The meter will begin to count
Make sure the result
53