Table of Contents
Advertisement
DMX Control Mode
To change the DMX starting address:
• Press <MENU> until
• Press <ENTER> to display the channel number, and press
<UP> or <DOWN> to select your starting address. (
• Press <ENTER> to assign your selection, then press and hold
<MENU> for three (3) seconds to confirm the change.
NOTE: If a valid DMX signal is not present, the fixture will au-
tomatically go into the selected standalone mode. See Stand-
alone Control Modes for more information.
To change the DMX mode (1, 2, 3, 4, 5, 6, or 7 channels):
• Press <MENU> until
• Press <ENTER> to display the mode, and press <UP> or
<DOWN> to select the DMX mode. (
• Press <ENTER> to assign your selection, then press and hold
<MENU> for three (3) seconds to confirm the change.
Page 10
is displayed.
Addr
is displayed.
ChNd
-
)
1CH
7CH
LED 36 User Manual rev. A
)
1-512
Advertisement
Table of Contents
