Table of Contents
Advertisement
Master/Slave Mode
Up to 32 LED PARs may be connected via the 3-pin DMX con-
nections and controlled simultaneously without a DMX control-
ler by using Master/Slave Mode. In this mode you can set one
fixture in the line to act as the master controller.
• Press <MENU> until
• Press <ENTER> to select, and press <UP> or <DOWN> to
select your desired mode.
sets the LED PAR as the Master. Other LED PAR fixtures
NASt
connected to this one and set as slave will be controlled by this
fixture.
turns off control of the LED PAR.
Noff
sets the LED PAR in Slave Mode 2. If this LED PAR is con-
SL 2
nected to another set in Master Mode, it will be controlled by
the Master fixture.
sets the LED PAR in Slave Mode 1. If this LED PAR is con-
SL 1
nected to another set in Master Mode, it will be controlled by
the Master fixture.
• Press <ENTER> to assign your Master/Slave selection, then
press and hold <MENU> for three (3) seconds to confirm the
change.
RGB Balance Mode
RGB Balance Mode adjusts the maximum LED level output for
every mode. If you change this setting, you will affect the
colors output for every preset mode. Make sure this is what
you want before changing these settings!
• Press <MENU> until
• Press <ENTER> to select. All Red, Green, and Blue LEDs will
be on at full.
• Press <UP> or <DOWN> to select the color you wish to
adjust. (
red Gree blue
• Color levels adjustable from 0-255.
• Press <ENTER> to assign selection.
• To confirm your changes and exit RGB Balance Mode, hold
<MENU> for three (3) seconds.
Page 16
is displayed.
SLNd
is displayed.
baLa
)
LED 36 User Manual rev. A
Advertisement
Table of Contents
