Oven Use - Miele H 4242 B Operating And Installation Instructions

IMPORTANT SAFETY INSTRUCTIONS
Installation
~
Before installation, make sure that
the voltage and frequency listed on the
data plate correspond with the
household electrical supply. This data
must correspond to prevent injury and
machine damage. Consult a qualified
electrician if in doubt.
~
Be certain your appliance is
properly installed and grounded by a
qualified technician.
To guarantee the electrical safety of this
appliance, continuity must exist
between the appliance and an effective
grounding system. It is imperative that
this basic safety requirement be met. If
there is any doubt, have the electrical
system of the house checked by a
qualified electrician.
The manufacturer cannot be held
responsible for damages caused by the
lack or inadequacy of an effective
grounding system or the failure to
adhere to national and local electrical
codes.
~
The oven is not to be operated until
it has been properly installed within
cabinetry.
~
Installation, maintenance and repair
work should be performed by an
authorized service technician. Work by
unqualified persons could be
dangerous and may void the warranty.
~
Before installation or service,
disconnect the power supply to the
work area by removing the fuse,
"tripping" the circuit breaker, or shutting
off the power main.
6

Oven use

,
WARNING: Ovens can produce
high temperatures that can cause
burns.
~
Prevent children from touching the
appliance while in use.
~
Use heat-resistant potholders when
placing items in the oven, turning them,
or removing them from the oven. The
upper heating element and oven racks
can become very hot and cause burns.
~
To prevent burns, always place
oven racks at their desired height while
the oven is cool.
~
Open the door carefully to allow hot
air or steam to escape before placing
or removing food.
~
To prevent burns, allow the heating
element to cool before cleaning by
hand.
~
The door gasket is essential for a
good seal. Care should be taken not to
rub, damage or move the gasket. The
door gasket should only be cleaned
with a solution of warm water and soap.
~
Only clean parts listed in this
manual.