Wheel Guard Installation; Side Handle - Bosch 1375A Operating Instructions Manual

BM 260914087 7/01 7/26/01

WHEEL GUARD INSTALLATION

Wheel guard must be
WARNING
!
attached when using disc
grinding wheels. Always keep wheel guard
between you and your work while grinding.
LOCK NUT AND BACKING FLANGE
Your tool is equipped with a threaded
spindle for mounting accessories. Always
use the supplied lock nut (and backing
flange) that has same thread size as spindle.
Disc Grinding Wheel Assembly
Disconnect tool from power source. Be sure
that wheel guard is in place for grinding.
Thread BACKING FLANGE onto spindle,
then place GRINDING WHEEL on the
spindle. Thread on the lock nut and tighten
nut using the supplied lock nut wrench,
while holding the spindle lock in.
TO REMOVE: Reverse procedure.
2:57 PM Page 7
Assembly
To attach the wheel guard DISCONNECT
tool from power source.
Position the guard on spindle neck, then
secure guard with the collar screw.

SIDE HANDLE

The side handle used to guide and balance
the tool can be threaded into the front housing
on either side of the tool, depending on per-
sonal preference and comfort. Use the side
handle for safe control and ease of operation.
WHEEL
GUARD
-7-
SPINDLE
COLLAR SCREW
BACKING FLANGE
GRINDING WHEEL
LOCK NUT