Wheel Guard Installation - Bosch 1752G Operating/Safety Instructions Manual

BM 1609929B61 3/03 3/12/03

WHEEL GUARD INSTALLATION

Wheel guard must be
WARNING
!
attached when using disc
grinding wheels. Always keep wheel guard
between you and your work while grinding.
To attach the wheel guard disconnect tool
from the power source, align wheel guard
locating tab with key way on mounting
flange and slip guard onto mounting flange.
Twist into place, always keep the wheel
guard between you and your work when
grinding. Tighten screw to secure wheel
guard.
LOCK NUT AND BACKING FLANGE
Your tool is equipped with a threaded
spindle for mounting accessories. Always
use the lock nut and backing flange that has
same thread size as spindle.
Disc Grinding Wheel Assembly
Disconnect tool from power source. Be sure
that wheel guard is in place for grinding.
When using spin-on grinding wheels, thread
directly onto the spindle.
When using mounting wheels, thread
BACKING FLANGE onto spindle, then place
GRINDING WHEEL on the spindle. Thread
on the lock nut and tighten nut using a lock
nut wrench provided with adapter kit, while
holding the spindle lock in.
TO REMOVE: Reverse procedure.
MOUNTING
FLANGE
WHEEL
GUARD
SPIN-ON GRINDING
WHEEL
10:48 AM Page 7
Assembly
CUP GRINDING WHEELS
Use cup grinding wheels for heavy-duty
stock removal of metals, concrete and
stone.
ADJUSTABLE CUP
WHEEL GUARD INSTALLATION
Open the guard clamp and fit it on the
mounting flange then secure by tightening
the clamp screw. ALWAYS HAVE THIS
GUARD ATTACHED WHEN USING CUP
GRINDING WHEELS
The adjustable guard allows you to lower or
raise the guard's shell. TO ADJUST: Loosen
the four bolts on the shell, and secure the
shell for 1/4" wheel exposure for maximum
safety.
ATTACHING CUP GRINDING WHEEL
Thread the cup grinding wheel on the
spindle shaft CLOCKWISE. Press in the
spindle lock button and turn the cup grinding
wheel until the lock button engages, then
tighten the wheel securely by hand.
TO REMOVE: Reverse procedure.
SPINDLE
SPINDLE
LOCATING
TAB
BACKING
FLANGE
DISC
GRINDING
WHEEL
LOCK NUT
-7-
MOUNTING
FLANGE
ADJUSTABLE
GUARD
SHELL
BOLT
CUP
GRINDING
WHEEL