Safety Cut-Out System - Adam CO9043 Use & Care Manual

CAUTIONS
• Always install the fire in accordance with this guide. If in doubt obtain
expert advice.
• Always make sure the electrical socket is accessible and located
Do's
adjacent to, but not above the fire.
• Always disconnect the fire from the electrical supply before carrying
out cleaning, maintenance or replacing the light bulbs.
• Always make sure the fire is firmly secured.
• Never leave children unsupervised in a room where the fire is ON and
unguarded.
• Never obstruct or cover the fan outlet or force items into fire openings.
• Never install or use the fire anywhere where water is in use, i.e.
Bathrooms, Kitchens, Shower Rooms, and Swimming Pool etc.
• Never use aerosols or steam cleaners on or around the fire.
• Never route the mains supply cable under carpet etc.
Don'ts
• Never install the fire close to curtains or combustible materials.
• Never use the fire to dry clothes etc.
• Never sit or stand on the fire.
• Do not use outdoors
• Never cut off the plug and hard wire into a fixed fused spur.
• Do not position furniture, curtains or other combustible material closer
than 1 metre from the heater.

SAFETY CUT-OUT SYSTEM

DO NOT OBSTRUCT THE AIR VENTS OF THE ELECTRIC HEATER.
This appliance has a 'self resetting' safety cut out system, that will activate if the air
inlets or outlets are obstructed. If the electric fire is obstructed, it will overheat. When
the temperature exceeds 85 degrees C, the heater element will cut out, until a safe
temperature is regained.
THIS PRODUCT MUST BE INSTALLED CORRECTLY. FAILURE TO DO
SO MAY CAUSE DAMAGE TO YOUR PRODUCT AND/OR YOUR
SURROUNDINGS
DO NOT INSET IN TO A WALL OR SURROUND. THIS IS A WALL
MOUNTED APPLIANCE ONLY
Helpline email address: helpline@adamsurrounds.co.uk
CO9043
Customer telephone helpline: 08448 809301
- 4 -
V3_151110