Problem Solving Guide - Miele Novotronic T 1565 C Operation Manual

Problem solving guide

Electrical appliances should only be repaired by qualified personnel. Incor-
rectly repaired machines may put the user at risk. There are, however, minor
problems which can be corrected without contacting the Service Department.
What to do if, . . . ?
. . . the tumble dryer fails to
start when turned on?
. . . the laundry is not
sufficiently dry?
. . . the drying times are too
long?
. . . the "anti-crease"
indicator lamp in the
sequence indicator display
starts flashing?
18
Cause . . .
Check whether the "On"
indicator lights up. If so, failure
to start may be due to an
incorrect program selection
procedure.
If the "On" indicator lamp does
not illuminate, check that:
The load consisted of dissimilar
items (size and fabrics).
Small loads or individual items
may cause the program to
terminate prematurely.
The lint filter is clogged.
The laundry was not spun in
the water for a sufficient time.
Remedy . . .
Repeat the switch-on
procedure in the correct
sequence, as outlined in the
"Program Selection" section.
– The "ON/OFF" button is
depressed.
– The door is properly closed.
– The machine is plugged in
and the fuse or circuit breaker
has not tripped.
Select a longer drying
program.
Small loads can be time-dried.
Clean the lint filter in the door.
Make sure that the laundry is
thoroughly spun before drying.
– Turn the program selector
to "finish".
– Turn the machine off and
then on again.
– Select a program.
– Press the "Start" button.
If the indicator lamp starts
flashing again, this indicates a
fault in the machine.
Please contact the Miele
Service Dept.