Advertisement
MENU "Input A/B" Input Channels Editing [Access by pushing the "A/B" buttons]
NAV/PAR1 Encoder
[to navigate between menus]
1. Input A/B
Gain
Gain = + 0.0 dB
ESC
ENTER
-> Gain = + 0.0 dB
2. Input A/B
Delay
Delay =
0.000 ms
ESC
ENTER
-> Delay =
0.000 ms
3. Input A/B
PEQ/SHV - 1/5
1.00kHz
BW/SHV_Slope=1.00/up to -12dB
ESC
ENTER
If through the PM2, being the filter's gain = 0.0dB,
has been selected a
Bell filter
BW to be greater then 0, then the Bell filters can be set by
the following parameters
3.1 Input A/B
EQ-X (up to 5 filters available)
-> 1.00kHz BW=1.00 +0.0dB
If through the PM2, being the filter's gain = 0.0dB,
has been selected a
Low Shelving filter
Slope (1
st
or 2
nd
order available, -6dB or -12dB), then the
Low Shelving filter can be set by the following parameters
3.2 Input A/B
EQ-X (up to 5 filters available)
-> 1.00kHz (-6/-12)LoSh
If through the PM2, being the filter's gain = 0.0dB,
has been selected a
High Shelving filter
Slope (1
st
or 2
nd
order available, -6dB or -12dB), then the
High Shelving filter can be set by the following parameters
3.3 Input A/B
EQ-X (up to 5 filters available)
-> 1.00kHz (-6/-12)HiSh
+ 0.0dB
, just defining its Bandwidth
, just defining its
+0.0dB
, just defining its
+0.0dB
NAV/PAR1 Enc .
[to chose values for the parameters, no need to confirm the chosen values,
which are automatically loaded during the encoders use]
PAR1 N/A
PAR1 N/A
(when the filter's gain = 0.0dB ONLY, through the PM2 it is possible to
chose and select between a Bell or a Shelving filter)
[Freq.] 20Hz
:
20kHz
[Freq.] 20Hz
:
20kHz
[Freq.] 20Hz
:
20kHz
6
PM2 Enc.
PM3 Enc.
-12 db
Same as PAR2
:
+6 dB
000.0000mS
000.0000mS
[1 ms steps]
[20.8 us steps]
848.0000mS
000.9984mS
[BW] 0.05
[Amp.] -15.0 dB
:
3.00
[Amp.] -15.0 dB
PM2 N/A
[Amp.] -15.0 dB
PM2 N/A
:
+15.0 dB
:
+15.0 dB
:
+15.0 dB
Advertisement
