Advertisement
6 WAY .. X OVER....... in this operating mode, the DPA-260A is performing a Mono Input to 6
Outputs X-Over, where the Input A is automatically assigned to the Outputs as follow:
–
Input
A
to
Out4=Mid-2, Out5=Far-1, Out6=Far-2]
By pressing ENTER on the System Setup page and rotating the"PM2"or"PM3"encoder, it
is possible to select all the available X-Over preset modes.
When the "2x3 WAY XOVER" is selected, the "System Setup" page will appear as follows
To change the desired operating mode for the DPA-260A, the screen must reflect the xover
required and then simply pressing the "ENTER" button will bring up the following screen asking
for confirmation to load the selected operating mode:
If confirmed by pressing ENTER the selected preset mode will load.
configuring the Xover the following screen will be appear :
The new preset mode will now be shown with an asterisk.
1/2/3/4/5/6
Outputs
System Setup
Setup: 2x3 WAY XOVER
New Xover
[ENTER] to confirm
Please Wait .....
Changing Xover
[Out1=Near-1,
Out2=Near-2,
*
10
Out3=Mid-1
and
:
While the device is
Advertisement
