Advertisement
Delay page – from this page it is possible to set the Output Channels Delay Time from
000.0000mS up to 848.9984mS, by steps of 1mS or 20.8uS.
To set the Delay time press ENTER an arrow will appear on the left of the screen " -> ". then use
the "PM2" encoder to set the Delay Time in steps of 1mS and the "PM3", for setting the "fine"
Delay Time in steps of 20.8 microseconds.
The following is an example screen for the "Delay" page where the Delay Time of Output Channel
1 is set to 160.1872mS:
Polarity page – from this page it is possible to set the Output Channels Polarity, by using the
"PM1" or "PM2" encoders.
The polarity can be "Normal" or "Inverted" (which means rotated of 180 Degrees).
The following is an example of a "Polarity" screen where the Polarity of Output Channel 1 is set to
"Normal"
Out-1
Name
-> Delay = 160.1872mS
Out-1
Name
-> Polarity =
Normal
Delay
Polarity
31
Advertisement
