Advertisement
Name page – from this screen it is possible to assign a 6 character name to the Output Channel.
The following is an example screen for a "Name" page labeled "Low" for Output Channel 1:
To Edit press ENTER on the Name Page and the entering arrow will appear as in the example
below:
The first letter position will be blinking.
Select the Character position from the 6 available by rotating the "NAV/PAR1" encoder, then by
using the "PM2" or
Once you are happy with your name selection, press"ENTER"to confirm the edited Name. The
new name will be stored. The following example shows "Sub" replacing our previous name of
"Low":
Source page – from this page it is possible to assign one of the following Inputs to any Output
Channel:
1. Input A
2. Input B
3. Sum of Input A/2 + Input B/2
The following is an example screen for the "Source" where Input A is assigned to Output
Channel 1:
After pressing ENTER an arrow will appear on the left of the screen"-> "the Input can be selected
by rotating either the "PM2" or "PM3" encoders.
Out-1
Name = Low
Out-1
-> Name = Low
"
Pm3" encoder it is possible to select the desired character.
Out-1
Name = Sub
Out-1
Source = InA
Low
Name
Low
Name
Sub
Name
Name
Source
29
Advertisement
