Table of Contents
Advertisement
SETTING PRIVACY CODES
Your LXT480 Series has 121 Privacy Codes available to use in
channels 1~22. The selected Privacy Code may be different for each
channel. To select a Privacy Code for the current channel press the
MENU button twice, and then the
38 CTCSS Privacy Code. Press again the MENU button and the
s\t
button to select one of the 83 DCS Privacy Code. The
Privacy Code icon on the display will indicate whether you set your
Privacy Code in CTCSS or DCS mode. To confirm the selection,
press the PTT button or press MENU button again to move to the
next feature setting.
Note : If you select any CTCSS Privacy Code, any pre-selected
!
DCS Privacy Code will be cancelled and vice-versa.
Selecting a Privacy Code of "oF" will disable the Privacy feature.
To communicate between two LXT480 Series radios, all radios in
your group must be set to the same channel and/or Privacy Code
selections. The Privacy Code can only be set in channels
1~22.
TRANSMIT (TX) POWER LEVEL SELECTION
Your LXT480 has 2 power level settings. To select the power level on
channels 1~7 and 15~36, press the MENU button until a "Pr" icon will
appear blinking on the display. Then press the
TRANSMIT POWER LEVEL icon (H: Hi/L: Lo). To confirm, press the
PTT button or press MENU button again to move to the next feature
setting. When the PTT button is pressed during Low Battery
Level condition, the TX Power will automatically switch from
Hi(H) to Lo(L) level.
!
Note : You cannot adjust the power setting on the FRS
channels (8~14). They are set to Low power per FCC
regulations.
VOX
Your LXT480 Series has 3 VOX level settings: (oF/1/2/3).
To set VOX, press the MENU button until the display shows "VOX"
blinking while on the right of the CHANNEL NUMBER display, an
"oF" icon appears. Select "1","2" or "3" by pressing the
and push the PTT key, or press MENU button again to move to the
next feature setting.
s\t
buttons to select one of the
s\t
buttons to select
s\t
buttons
Advertisement
Table of Contents
