Lcd Display; Battery Installation - Midland X-Tra Talk LXT360 Series Owner's Manual

LCD DISPLAY

1
2
3
CONTROLS
7
8
9
10

BATTERY INSTALLATION

Your LXT360/365 Series radio operates with either 4 AAA alkaline
batteries or an optional NiMH battery pack. The belt clip should be
removed (see below) to ease installation or removal of the batteries.
To install the batteries:
1. With the back of the radio facing you, remove the belt clip (see
diagram below) for easy access, then remove the Battery Cover by
pressing down on the top center and sliding it down from the radio.
2. Insert 4 AAA batteries observing the polarity as shown. Installing
the batteries incorrectly will prevent the unit from operating or may
damage the unit.
3. Return the Battery Cover by sliding it up on the radio. Replace the
belt clip, making sure it locks into place.
1. LOW BATTERY ICON – Indicates the
battery level is low.
2. TRANSMIT (TX) ICON – Indicates
4
radio is transmitting a signal.
3. CHANNEL NUMBER – Changes from
5
1~22 on GMRS/FRS band.
4. KEY LOCK ICON – Indicates KEY
6
LOCK mode is on.
5. RECEIVE (RX) ICON – Indicates
radio is receiving a transmission.
6. TRANSMIT POWER LEVEL ICON –
Indicates TX Power setting (H/L)
7. PTT Button – Press and hold to trans-
mit voice communication.
11
8. CALL/LOCK Button – Press to send
a CALL Alert signal. Press and hold to
turn KEY LOCK on/off.
9. MIC – Built-in microphone.
10. SPEAKER – Built-in speaker.
12
11. ANTENNA
12. EXTERNAL SPEAKER/MIC/CHG.
JACK
13
13. POWER / MENU Button – Press and
hold for at least 3 seconds to turn the
14
radio on/off. Press momentarily to
access Menu mode.
15
14. SCAN Button – Press to enter SCAN
mode.
15. UP
adjustments in MENU mode.
s s t t
and DOWN Button – Make