Table of Contents
Advertisement
c. Position the deflector (7) and upper support strap
(8) over the broom hood and deflector strap
assembly. Secure the deflector through the sec-
ond hole at the top of the deflector strap and
broom hood using one bolt (9), washer and nut
(5).
2. Raise and support the broom head assembly about
2"off the ground. Loosen the standard caster assem-
bly by loosening the locking lever (2, Figure 24) and
remove the caster assemblies. NOTE: Save the
standard casters for future use.
3. Position the debris box assembly (6) in-front of the
power broom.
4. Remove hitch pin (5), releasing debris box mounting
tubes (3).
5. Raise the power broom upwards and insert the
mounting tubes (3) through the mounting brackets
(1) on the broom frame.
6. Position the debris box assembly under the broom
assembly and lower the broom assembly onto the
debris box mounting brackets.
7. Insert hitch pin (5) to secure the broom assembly to
the debris box. Install hairpin cotter pin (4) to secure
the hitch pin.
8. The final assembly is shown in Figure 25.
9. Adjust the broom height to according to the Broom
Height Adjustment instructions earlier in this manual.
5
4
6
Figure 24. Debris Box Installation
Figure 25. Debris Box/Power Broom Final Assembly
25
Optional Equipment
1
2
3
3
4
5
Advertisement
Table of Contents
