Table of Contents
Advertisement
Service
6. Reverse the procedure to install the belts. Be sure
there are no twists and the belts are properly seated
in the grooves. Adjust the belt stops so there is 1/8"
(3mm) clearance between belt and stop. The pattern
for both belts is shown in Figure 19. Slide the right
axle left fully before tightening the set collar (E,
Figure 18).
7. Check the traction drive tension and broom drive ten-
sion. Follow the procedures under BROOM/TRAC-
TION DRIVE TENSION.
8. Make sure the broom stops when the broom drive
lever is released. Make sure traction drive stops
when the traction drive lever is released. If not, check
the drive tension. If a problem exists, see your dealer.
D
B
A
Figure 18. Broom Pulley Belt Stops
(shown with bottom cover removed)
A. Nuts
B. Belt Stops
C. Broom Pulley
D. Gear Assy. Bolts
E. Set Collar
E
C
D
F
Figure 19. Belt Pattern (viewed from front)
A. Engine Pulley
B. Drive Belt
C. Idler Pulley
D. Driven Pulley
E. Engine Belt Stops
F. Broom Pulley Belt Stops
22
E
C
B
A
E
A
B
F
Advertisement
Table of Contents
