Table of Contents
Advertisement
Operation
BRUSH ANGLE ADJUSTMENT
To change the angle of the brush:
1. Pull upwards on the Brush Lock Swivel Lock handle
(A, Figure 3) and hold. This will release the brush
swivel lock pin (B).
2. With the brush assembly resting on the ground,
rotate the brush frame to the right or left.
3. When the brush is in the proper position, release the
brush lock swivel lock handle. The brush assembly
will be locked in the selected position. NOTE: The
brush can be positioned to either the right, left or
straight ahead.
CAUTION
If brush height is set too low, brush can drive
machine rearward when attachment clutch is
engaged. Engage brush slowly with brush set at
proper height.
BRUSH HEIGHT ADJUSTMENT
For hard surfaces, adjust the caster wheels so that brush
just touches surface. The brush works best with the
brush properly leveled. To adjust the brush height:
1. Move the brush to a dusty, flat surface. Leave the
engine running.
2. Start the brush at a slow speed. Run the brush in a
stationary position for 30 seconds.
A
Figure 3. Brush Angle Adjustment
A. Brush Swivel Lock Handle
B. Swivel Lock Pin
B
3. Lift the brush head assembly off the ground and
reverse the unit to move it away from the swept area.
4. Stop engine and allow all moving parts to stop.
5. Check the width of the swept area. The brush pattern
should be 2-3 inches wide, running the length of the
brush. (See Figure 4)
6. To adjust
a) Loosen the caster wheel lock lever.
(See A, Figure 5)
b) Raise or lower the caster wheel as needed.
c) Tighten the caster wheel lock lever.
NOTE: If using the power broom for turf applications,
less ground contract is required.
Figure 4. Brush Sweeping Pattern
A. Caster wheel lock lever
Figure 6. Easy Turn Control
12
A
Advertisement
Table of Contents
