Pride CELEBRITY X SPORT Owner's Manual page 35

V I I . D I S A S S E M B L Y A N D A S S E M B L Y
ASSEMBLY
1. Position the front and rear sections of your
scooter as shown in figure 27.
2. Use the frame release lever to lift the front sec-
tion as you align the frame hooks of the front
section with the lower frame tube of the rear
section. See figure 27.
3. Once the frame hooks are over the lower frame
tube, lower the front section completely. This
will engage the frame lock. See figure 26.
4. Raise the tiller and fully tighten the tiller adjust-
ment knob.
5. Reinstall both batteries and secure with the tie-
down strap.
6. Connect the front-to-rear harness, rear lighting
harness and both battery harnesses. See figure 23.
7. Reinstall the rear shroud.
8. Reinstall the seat and rotate it until it locks into
place.
9. Unlock the front wheel by turning the tiller lock
knob 90° anticlockwise. See figure 22A.
WARNING! After assembly, make
absolutely certain the tiller lock
knob is in the unlocked position
Celebrity X Sport
FRAME RELEASE LEVER
Figure 26. Frame Release
UPPER FRAME TUBE
Figure 27. Frame Separation
www.pridemobility.com
LOWER FRAME TUBE
FRAME HOOK
FRAME HOOK
35