Pride CELEBRITY X SPORT Owner's Manual page 34

V I I . D I S A S S E M B L Y A N D A S S E M B L Y
4. Gently pull the rear shroud up and off of the
rear section of the scooter.
5. Unplug the front-to-rear and rear lighting
harnesses by squeezing the sides and pulling
straight up.
6. Unplug both battery harnesses. Pull each
harness straight up. See figure 23.
7. Unfasten the battery tie-down straps and
remove the batteries from the battery wells.
WARNING! Failure to unplug both
battery harnesses, the front-to-
rear harness and rear lighting
harness prior to separating the
front and
result in permanent damage to the
scooter.
Handbrake Cable Disconnect
1. Locate the quick disconnect body. See figure 24.
2. Pull the quick disconnect handle back from the
quick disconnect body.
3. Position the quick disconnect handle over the
top of the quick disconnect body.
4. Separate the brake cable from the cable clamp
located inside the quick disconnect body. See
figure 25.
Frame Separation
1. Lift up on the frame release lever. See figure 26.
2. Lift the front section up until the frame hooks
of the front section separate from the rear sec-
tion. See figure 27.
NOTE: Stabilise the rear section with your free
hand by holding onto the upper frame tube.
3. Slowly separate the two sections. See figure 27.
34
rear sections could
www.pridemobility.com
REAR LIGHTING HARNESS
BATTERY HARNESSES
Figure 23. Harness Connections
QUICK DISCONNECT HANDLE
QUICK DISCON-
NECT BODY
Figure 24. Quick Disconnect Handbrake Cable
Figure 25. Handbrake Cable Release
FRONT-TO REAR HARNESS
Celebrity X Sport