Page 1
PROFESSIONAL AUDIO SYSTEM SF15DC OPERATING MANUAL Ver. SF15DC-EN-1.0 LSS Advanced Speaker Systems Via On. Longo 53-89024 Polistena (RC) ITALY Tel (39) 966 9321299 – Fax (39) 966 933007 Email: info@lss.it - Internet: www.lss.it...
Page 2
Every precaution has been taken in the preparation of this manual. Nevertheless, LSS assumes no responsibility for errors or omissions. Neither is any liability assumed for damages resulting from the use of the information contained in this publication.
LSS produces professional audio products – the result of exceptional engineering and meticulous craftsmanship. This manual is intended for use with LSS loudspeaker. This includes: safety precautions; installation, set-up and operating instruction. Please read this manual plus any accompanying manual and follow all relevant precautions and instructions.
LSS loudspeakers can produce sound levels capable of causing permanent hearing damage from prolonged exposure. The higher the sound level, the less exposure needed to cause such damage CAUTION: This product is energized as long as it is connected to the AC.
SF15A digital amplifier with DSP controller allows the pilotage in BI-AMP mode 750W for LF woofer + 200W for HF driver. LSS's SF15DC was designed as main speaker in live events, as monitor system, front or delay fill and can be used stand alone or with one or more other loudspeaker to create horizontal array.
SF15 speaker can be mounted on the floor, on a pole or suspended through the dedicated hardware. For installation on a pole, use the pole mount plate in the bottom of the case, speaker can be mounted on a tripod or on another speaker like a sub. 8| Operating Manual ver. SF15DC-EN-1.0...
Page 9
______________________________________________________________________________ Mounting hardware for SF15DC is composed from: Name Component BUMPER SF15 LIFTBAR SF15 ALUBAR SF15 GRILLO16 SF15 JOINT SF15 BOLT M8 X 40 Operating Manual ver. SF15DC-EN-1.0 |9...
Page 10
SF15DC_______________________________________________________________________________ SF15DC speaker can be mounted on the floor, on a pole or suspended through the dedicated hardware. For installation on a pole, use the pole mount cup in the bottom of the case. For suspended installation, follow the procedure below: Insert ALUBAR SF15 in the guide slots on the sides of the case.
Page 11
ALUBAR SF15 in the upper and lower guide slots on the sides of two adjacent cases. Install BUMPER SF15 as previously explained and connect it with the LIFTBARs using four GRILLO16. Another GRILLO16 can be used to hook the BUMPER Operating Manual ver. SF15DC-EN-1.0 |11...
Page 12
To connect a case with the lower one use the JOINT SF15, then lock them with the locking pin. It is possible to install a maximum of three speaker in horizontal configuration and three in vertical configuration. Use plugs suitable to support the weight of the entire apparatus. 12| Operating Manual ver. SF15DC-EN-1.0...
Warning: If the product is used for business purposes, the following steps to delete it: contact your LSS dealer for information about the product recall. Might be charged for the costs of collection and recycling. Small products (and amounts) might be taken back by your local collection facilities.
Poor system hissing, grounding or ground Check and correct the system grounding, as required. humming loop If these suggestions do not solve your problem, contact your nearest LSS dealer or LSS distributor. Operating Manual ver. SF15DC-EN-1.0 |15...
Need help?
Do you have a question about the SF15DC and is the answer not in the manual?
Questions and answers