Samsung SMARTCAM SNH-V6414BN User Manual page 9

If installing on a concrete wall, mount the
4.
bracket using screws and anchors. First,
mark the wall to which you want to attach
the bracket as shown in the figure.
On the mark, drill a hole to a depth of about
5.
3cm in the wall using a drill bit and drill with a
5mm diameter for concrete. Remove any
debris remaining in the hole after drilling.
Use caution when drilling to avoid injury.
`
J
Insert an anchor in each of the 2 holes for the
6.
screws, then hit the back of the anchor with a
hammer or a rubber mallet until it is
completely inserted.
Insert a screw in each of the 2 holes in the
7.
wall, and tighten the screws using a Phillips
screwdriver.
Connect the adapter plug to the power
8.
terminal of the camera.
If necessary, adjust the angle of the cable clip
9.
and plug in the power cable.
If the bracket hinge becomes loose, remove the
10.
rubber cover and tighten the screw using a
screwdriver.
Adjusting the camera angle
Place the camera stand on a flat
1.
surface.
Adjust the camera's shooting angle as
2.
appropriate.
` If the bracket hinge becomes loose,
n
remove the rubber cover and tighten the
screw using a screwdriver, then adjust the
direction of the camera.
02
9