Stadler Form Jack Operating Instructions Manual page 10

3. You can start Jack by pushing on the on/off button (8). You can now see
the current humidity on the display (8). If for any reason the display shows
tank (2) prior to pushing the on/off button.
4. By pushing repeteadly on the button for output (9) you can choose your
desired output level from small to high output.
5. If you push the button for the humidity level (10) you can choose the rela-
off as soon as the desired relative humidity is reached. If you desire to run
6. With the button for the pre heating (11) you can switch on the pre heating.
higher output. If you see the point in the lower right corner of the display (4),
the pre heating is switched on.
7. As soon as you see the information „no" in the Display (4), the water tank
it. After placing the water tank at its original position, Jack switches on
again automatically.
Note: Should you seen droplets (or other signs of dampness) on or around
Please turn the output down so that droplets are no longer visible.
Before you clean the appliance always switch off and unplug the plug from
the socket.
Attention: Never submerge the unit in water (danger of short circuiting).
ionic silver cube (12). Then you can clean the ultrasonic membrane with a
then you can clean the ultrasonic membrane with the help of the cleaning
brush (front or reverse side). Please try not to scrape the membrane with a
the unit several times in a row. After decalcifying, rinse the lower part and
then dry thoroughly.
be visible, you can also decalcify the water tank. Afterwards, rinse out the
water tank and then dry.
The ionic silver cube (12) prevents the growth of germs and bacteria in the
silver cube leads to a hygienic room climate. The lifetime of the ionic silver
cube is around one year. We therefore recommend that you replace the ionic
silver cube at the beginning of every humidifying season. The ionic silver
cube starts working as soon as it comes into contact with water, and also