Notes On Disc - Teac TE-269 Installation Manual

3) While holding down the button on the steering wheel and the corresponding button on
the SWC interface it will display complete setting. When all the buttons on the steering
wheel and the corresponding button on the WHEEL CTRL interface complete setting,
you can use the steering wheel button to operation the unit. Such as in radio mode,
press button or
press button or
reverse (REW) search or fast forward in a track. Press VOL+ button or VOL - button
to adjust the volume.
Note ： 1.The "Enter" button and the "reset" button are not included in steering wheel,
press the "enter" button to confirm the select, press the "reset" button to clear the former
select.
2. The restriction of use SWC is the voltage between the adjacent buttons are
above 0.2 V that can be identified.

NOTES ON DISC

Only use groundless loudspeakers.
Use only loudspeakers of minimal 40Watt, using fewer watts may result in damaging
your loud speakers at higher volumes.
Use 4~8 Ω (Ohm impedance) loudspeakers only; using higher or lesser impedance
may damage the unit.
Do not use 3-cable loudspeakers and do not connect the loudspeakers minus to the car
body.
(GND). using a BTL circuit and each loudspeaker must be connected with insulated
cables according the diagram.
Loudspeaker cables and/or optional external power amplifiers must always be about
30cm. away from the antenna and/or antenna extension parts.
If want to display for 6.2" TFT, parking wire must be connected to ground.
button to search station backward or forward; In DVD mode,
button to select the previous or next track and activate fast
25
INSTRUCTION MANUAL