Troubleshooting - Motorola PMMN4095 series User Manual

Table 5.3: Charging Status (Continued)
Battery under voltage recovery time out
Loss of charge current control
Fast Flash Red
Excessive power supply voltage
Fault connection happened
– DO NOT charge battery
If battery is inserted into a successfully powered
up charger, battery may have bad contact with
Off
OR
OR
OR
charger

Troubleshooting

If There is Fast Flash Red Indication:
1
Confirm the battery being used with the WRSM is listed in Table 5.1
and is good in condition.
2
Remove the battery and restart the Vehicular Charger.
3
If the symptom persist, please send the Vehicular Charger to the
nearest Service Center for further verification.
If There is No LED Indication:
1
Check that the WRSM with battery or the battery is inserted
correctly in the pocket.
2
Make sure that the CLA adapter is plugged into a CLA power
source and the LED on the CLA adapter is on.
3
Confirm that the battery being used with the WRSM is listed in
Table 5.1 .
39
English