SPOT SETUP
At the spot monitor output all cameras are
shown in sequence. In case of an event
(ALARM OR MOTION) the spot monitor will
show the corresponding channel.
-
SWITCHING INTERVAL
Here you can set the switching interval of
the spot monitor.
- ALARM POPUP
Here you can set if in case of an ALARM the corresponding channel should be shown.
- MOTION POPUP
Here you can set if in case of a MOTION the corresponding channel should be shown
- EVENT POPUP DURATION
Here you can set how long the event should be shown on the spot monitor.
10.5 Back-Up
USB-BACKUP
-
HDD
Here you can see when the recording
started and ended.
-
MEDIA
- PARTITION: Shows the size and
available space of the USB media.
- START: Here you can select the start
point of the backup.
- END: On basis of the available space
of the USB media the end time will
automatically be calculated.
- SIZE: Here you can adjust the size of
the backup. The end time will be
automatically recalculated.
-
BACKUP
Click here to start the backup.
SWITCHING INTERVAL
ALARM POPUP
MOTION POPUP
EVENT POPUP DURATION
DEFAULT
USB-BACKUP
HDD
START
07/11/2007
END
09/11/2007
MEDIA
PARTITION
START
07/11/2007
END
SIZE
USB STORAGE IS BEING CHECKED
BACKUP
56
SPOT SETUP
MB ->
03 SEC
OFF
OFF
05 SEC
ESC
17:46:14
11:10:41
17:46:14
MB
ZURÜCK