Maintenance And Care; Switching The Appliance Off; Cleaning The Appliance; Cleaning The Oven Door - Indesit FGIM K Operating Instructions Manual

Maintenance and care

Switching the appliance off

Disconnect your appliance from the electricity
supply before carrying out any work on it.

Cleaning the appliance

! Never use steam cleaners or pressure cleaners on
the appliance.
• The stainless-steel or enamel-coated external
parts as well as the rubber seals may be cleaned
using a sponge that has been soaked in
lukewarm water and neutral soap. If these stains
are difficult to remove, use only specialised
products. After cleaning, rinse and dry
thoroughly. Do not use abrasive powders or
corrosive substances.
• Ideally, the inside of the oven should be cleaned
after each use, when it is still lukewarm. Use hot
water and detergent, rinse and dry with a soft
cloth. Do not use abrasive products.
• The accessories can be washed like everyday
crockery and may even be cleaned in the
dishwasher.

Cleaning the oven door

Clean the glass part of the oven door using a
sponge and a non-abrasive cleaning product, then
dry thoroughly with a soft cloth. Do not use rough
abrasive material or sharp metal scrapers as these
could scratch the surface and cause the glass to
crack.
To clean the oven more
thoroughly, you can remove
its door:
1. Open the oven door fully
( see diagram ).
2. Lift up and turn the small
levers situated on the two
hinges. ( see diagram ).
3. Grip the door on the two
external sides and close it
approximately half way. Pull
the door towards you,
extracting it from its hinges
( see diagram ). To replace the
door, reverse this sequence.
Inspecting the seals
Check the door seals around the oven regularly. If
the seals are damaged, please contact your nearest
After-sales Service Centre ( see Assistance ). We
recommend that you do not use the oven until the
seals have been replaced.

Replacing the light bulb

Assistance

! Never use the services of an unauthorised
technician.
Please have the following information handy:
• The type of problem encountered.
• The appliance model (Mod.).
• The serial number (S/N).
The latter two pieces of information can be found on
the data plate located on the appliance.
To replace the oven
light bulb:
1. Remove the glass
cover of the lamp-
holder.
2. Remove the light
bulb and replace it with
a similar one: Wattage
25 W, cap E 14.
3. Replace the glass
cover ( see diagram ).
23
GB