Yamaha MCR-940 Owner's Manual page 49

Problem
There is no picture. The video cable is not connected properly
to your TV.
The input setting on your TV is not
correct.
The BD player is not set properly for
HDMI or component video cable
connection.
The screen freezes The disc is damaged or dirty.
and operation
The BD player is frozen.
buttons do not work.
There is sound but The video cable is not connected
no picture. properly.
An image is not The video output resolution setting does
output with the
not match the resolution of the TV
desired resolution. connected to the BD player.
"Video Out Select" is not set properly.
"Component Video Out" or "HDMI
Video Out" is not set to the desired
resolution.
Widescreen images
"TV Aspect Ratio" is not set properly for
look vertically the connected TV.
stretched, or black
A 4:3 standard TV is connected but
bands appear at the
"Video Out Select" is not set to
top and bottom of the
"Component".
screen.
4:3 images look
horizontally
stretched.
Block noise (mosaic)
Block noise may appear in fast-moving
appears on the scenes due to the characteristics of digital
screen. image compression technology.
Sound or images are The sound or image may not be output
not output properly. properly when playing back a copyright-
protected disc.
Sound is distorted or The RCA stereo cable is not connected
not output.
between the receiver and the BD player.
The audio plugs are dirty.
The surface of the disc is dirty.
The disc is damaged or dirty.
Cause
Connect the video cable properly to the TV.
Select the correct input setting on the TV.
Set the BD player properly.
Check the disc surface.
Reboot the BD player.
Connect the cable properly.
Perform "VIDEO RESET".
Switch between "HDMI" and "Component" by using
"Video Out Select" or "HDMI <-> COMP".
Set "Video Out Select" properly.
Set "Component Video Out" or "HDMI Video Out"
to the desired resolution.
Set "TV Aspect Ratio" properly for the connected
TV.
When a widescreen TV is connected, set "TV Aspect
Ratio" to "Wide 16:9".
When a 4:3 standard TV is connected, set "Video
Out Select" to "Component".
When a 4:3 TV is connected, set "Video Out Select"
to "Component".
Connect the RCA stereo cable between the receiver
and the BD player.
Clean the audio plugs.
Clean the disc surface.
Check the disc surface.
TROUBLESHOOTING
Remedy
See
page
9
13
33
—
5
9
41
33, 41
33
33
33
33
33
8
—
48
—
45
En