Advertisement
_____________________________________________________________________________
Refer to the picture below. Wrap some electrical tape around the coax
center and shield. Then, using the supplied stainless steel hardware,
connect the coax center connector to the S9v vertical element wire. (The
bolt head should face the base tube, as shown below.) Secure the coax
center lead to the bottom of the base tube with electrical tape.
Next, connect the coax shield to a convenient hole on the radial plate.
Now, skip to step "c" on page 22.
Connect coax shield to any
convenient point on the
radial plate
________________________________________________________________________
Connect coax
center to S9v
vertical element
wire
S9v 31' M K II Installation Guide
Wrap electrical
tape around coax
center lead to
secure it to the
base tube
22
Coax to 1:1
choke balun
Advertisement
