Advertisement
_____________________________________________________________________________
h. The top tip section does not require a tube ring. To secure the top section,
hold the section below it with one hand and firmly twist and pull the tip
section with your other hand until it is firmly friction-locked in place.
NOTE: The antenna should now be fully extended and laying on the
ground and all sections (except the top section) should have
the tube rings installed.
i. Now, let's retrieve the vertical element wire from the base tube. Rotate the
base tube until you see the wire exit hole.
j. Use the supplied hook tool to grab the wire and pull a small U-shaped
portion of the wire through the exit hole, as shown below.
Once you get a small U-shaped portion of the wire out of the exit hole, you
can gently twist the tool, if needed, to help retrieve the wire. Now STOP
and carefully remove the tool. Next, hold the top part of the wire firmly in
one hand while you use your other hand to pull the lower, loose end of the
wire out through the hole. Do not pull on the top part of the wire – just pull
on the lower, loose end!
________________________________________________________________________
S9v 31' M K II Installation Guide
18
Advertisement
