Advertisement
_____________________________________________________________________________
6. Connect Coax Feed Line to Antenna.
If you are using the S9v as a 40 meter monoband vertical, proceed with step
"a", below.
If you are using the S9v as a multi-band antenna (40 – 6 meters), skip to step
"b" on page 22 now.
a. If you are using the S9v as a 40 meter monoband vertical, position the
1:1 choke balun in-line with your coax feedline, outside of the radial field.
Then, solder the two supplied ring terminal connectors to the antenna end
of your coax feed line. To prepare the coax, remove about 3 inches of the
coax outer jacket. Leave the braid 3 inches long and trim back the center
connection to around 1-1/2 inches long. Then, solder the center and
shield coax connections to the ring terminals.
About 3 Inches
About 1-1/2 Inches
________________________________________________________________________
S9v 31' M K II Installation Guide
Solder Coax Shield to Ring
Terminal
Solder Coax Center to Ring
Terminal
21
Advertisement
