Level Select Key; Split - Galileo YP300 Owner's Manual

YP300/GYP300
owner's manual
LEVEL Select
The Level slider has two different functions, it can adjust Brilliance
or Balance.
By pressing the Level Select button you can alternatively switch
between the two modes. The amount of the two functions is
controlled by the potentiometer.
Brilliance: allows you to change the brightness of the sound produced
by YP300/GYP300. To lower the sound brilliance simply move the slider
to the left, moving the slider to the right will increase brilliance and you
will get a brighter sound.
Balance: allows you to modify the balance between the three sound
parts of YP300/GYP300 when you are playing in dual or split mode.
Below we see the part configurations and how these are influenced by
Balance:
1. If you play the piano in "single mode" the level select is locked to brilliance.
2. In the "Layer mode" you can adjust the balance between the two sounds that compose the
Layer.
3. In the "Split mode" with Bass/Sound + Single Sound, the level slider controls the balance
between Bass/Sound and Single Sound.
4. In the "Split mode" with Bass/Sound + Layer Sound, the level slider controls the balance
between Bass/Sound and Layer, and the two layered sounds are adjusted by the same amount
If Balance is active, and you switch from one configuration with multiple parts to a single
sound, Level Select automatically selects Brilliance.
When Brilliance is active and you switch from a single sound to a multi-part configuration,
Level Select automatically selects Balance. Whenever you change level select mode (from
Brilliance to Balance and vice versa), the current level of the old mode is stored in memory,
while the last stored level of the new mode will become the current level.

SPLIT

(divide the keyboard in two parts)
The split controls allow you to activate the split (divide the keyboard in two parts), to select
the active split sounds, and select the split points for your Bass and upper part Sounds
SPLIT Bass:
To activate the Bass Sound on
the left hand press the BASS
button. The Bass sound selection
is illustrated by the
corresponding led on the panel.
Press the Bass button to change
the Bass Sound. To exit the Split
Bass mode press the button until
the LED associated with the
sound is off.
SPLIT Sound:
To activate the Sound Preset on the left hand press the Sound button. To select a Sound
preset, press and hold the Sound button (the button light will start flashing and will turn the
active PRESET), select the desired PRESET, then press the SOUND button that turns on with
the chosen sound.