Galileo YP300 Owner's Manual page 17

owner's manual
LOC: This function allows you to properly connect the piano to a computer or to a MIDI device.
If you select OFF, MIDI messages will be sent only to the connected device and not to the
generation of the instrument.
Default: ON.
To change the status of this feature (On / Off) use the buttons TEMPO/DATA.
(F9) Backup
With this function you can decide which configuration to start the piano when turned on. You can
choose to use the Factory settings (Backup OFF) or your custom settings (Backup ON), which
includes all of the panel settings (Sounds, Reverb, Effects, Sends, Touch, etc.).
Default: OFF. Use the TEMPO/DATA button to edit the value
Default: OFF.
Set OFF using the DATA buttons.
(F10) Help
To disable or enable the voice-help in the function menu.
Default: ON.
Set OFF using the DATA buttons.
(F11) Restore deafaults
This will Restore Factory Settings on the piano. The sequencer memory will be erased.
Default: YES.
Set NO using the TEMPO/DATA buttons.
Set YES and press ENTER to confirme the factory reset: the piano will re-start.
(F12) Firmware version
This function will illustrate the software release number on your YP300/GYP300 piano.
(F13) Standby
Enable (ON) or Disable (OFF) the auto-off function of the piano, after a period of inactivity.
The default value is set to ON and implies that the instrument goes into standby mode after 30
minutes of inactivity. Set the value to OFF to disable the standby function.
Default: ON.
YP300/GYP300