Table of Contents
Advertisement
A
B
TRIGGER
AUTO POWER STANDBY
ON
OFF
SPEAKERS L CH
A
+
+
B
A OR B:4 MIN. /SPEAKER
A+B:8 MIN. /SPEAKER
3
A AUTO POWER STANDBY switch
ON: The unit enters STANDBY mode automatically
if not operated for 8 hours.
OFF: The unit does not enter STANDBY mode
automatically.
B TRIGGER IN jack
Use this jack to connect an external component for the
trigger function.
For details on the connection, see page 22.
C REMOTE IN/OUT jacks
Use these jacks to connect an external component for
remote control.
For details on the connection, see page 21.
D SYSTEM CONNECTOR
Use this connector to connect a product testing device
for servicing.
E AC IN inlet
Use this inlet to plug in the supplied power cable.
For details on the connection, see page 19.
C
D
REMOTE
SYSTEM CONNECTOR
IN
IN
OUT
AC IN
E
F
F Foot
The feet of this unit include built-in spikes. Using the
spikes can reduce the effect of vibrations on the set.
When using the spikes, remove the transport tape, then
remove the magnet foot by pulling it.
Transport
tape
Caution
• Take care that the magnet foot is not accidentally
swallowed by small children.
• When using the feet's built-in spikes, the spikes may
scratch the shelf or floor on which this unit is installed. Use
the magnet feet or appropriate supports when placing this
unit on expensive furniture, etc.
y
If this unit is unstable, you can adjust the foot height by
rotating it.
Spike
Magnet
foot
11
En
Advertisement
Table of Contents
