Load & Show - Rancilio CLASSE 10 USB Use And Maintenance

W23 Interr. EV cold 4-TEA
W24 EV hot 4-TEA shorted
W25 Interr. EV hot 4-TEA
W26 EV steam iSteam shorted
W2 Interr. EV steam iSteam
W30 EV air iSteam shorted
W31 Interr. EV air iSteam
W32 Check the message file
10. LOAD & SHOW
Inserting a USB key into port 20 (fig. 3) will automatically upload the LOAD & SHOW interface, through which
it is possible to perform the following operations:
1. Machine software:
2. Graphics:
3. Messages:
4. Parameters:
Note:
● The files that need to be uploaded must be copied directly onto the USB key, without first putting them into
a folder.
● Never switch the machine off during the upload procedure.
** Features of the logos that can be
uploaded
Static logo
Up to 4 static logos can be displayed on the Class
10.
In order to be uploaded into the machine system, the
logos must have the following features:
- bitmap image (.bmp)
- 240x64 pixel resolution
- 2-colour image (1 bit)
84
software updating procedures.
uploading of any static or dynamic customisation logos**.
updating of the machine messages (provides new language
upload options).
enables uploading of another machine's parameters or downloading
parameters - currently in use on Class 10.
GRAPHICS
MESSAGES
SETTINGS
SOFTWARE MHX
LOGO 1
LOGO 2
LOGO 3
LOGO 4
MESSAGE.MSG
READ
WRITE
Dynamic logo
One animated logo can be displayed on the Class
10.
In order to be uploaded into the machine system, said
logo must have the following features:
- bitmap image (.bmp)
- Max. 1280x64 pixel resolution
- 2-colour image (1 bit)
LOGO1.BMP
LOGO2.BMP
LOGO3.BMP
LOGO4.BMP
SETTING.PAR
SDE07 PAR