Front Panel; Rear Panel - Blade BM5000S User Manual

1. Front Panel

1. POWER KEY: To switch the receiver power on/stand by
2. MENU KEY: To open the main menu
3. CH +/-: To select the next or previous saved channel or to move cursor up/down in the menu
4. VOL+/-: To increase/decrease the volume level or move cursor left/right in the menu
5. OK KEY: Enter the selected menu or channel
6. VFD (Vacuum Florescent Display) : Indicate the channel information and the current status
7. Remote Sensor: Detects infrared signal from remote control unit
8. POWER Indicator: Lights up when the receiver is powered on
9. CA Slot: Insert a CA Card (Supports Single CA interface-ISO7816)
10. USB Port: USB 2.0, connect to USB hard disk or flash disk

2. Rear Panel

Please refer to the diagram above for all possible connections of your receiver
Do not connect the unit to the mains socket until all other connections have been made and checked.
Your configuration may vary depending on model.
1. POWER ON/OFF SWITCH: To switch ON/OFF the receiver power supply.
2. INPUT (LNB IN 13/18V 500mA MAX): Connect the coaxial cable from LNB of your Dish.
3. HDMI: Audio and Video output socket for TV set with HDMI Input Jack only.
4. RS232 SERIAL PORT: To transfer the data to another STB or PC by RS-232 cable
5. YPbPr: Analog component video output
6. VIDEO: Used to connect any external video.
7. AUDIO R/L: Used to connect any external audio amp or system.
8. OPTICAL: Digital Audio Output via Optical SPDIF Port
9. Ethernet PORT: Plug-in Ethernet Board(RJ45 Port)
10. USB Port: USB 2.0, connect to USB hard disk or flash disk
5