Service And Maintenance - Festool TXS Original Operating Manual


The speed of the machine depends on how far
the on/off switch is pressed in.
9.2 LED lamp with capacity indicator
The LED bulb [1-10] lights up when the ON/OFF
switch is pressed [1-6].
After releasing the ON/OFF switch [1-6] the capac-
ity indicator on the LED lamp [1-10] displays the
state of charge of the battery pack for a few sec-
onds:
100%
0%
9.3 Bit store [1-11]
Magnetic, for storing bits and bit holders.
9.4 Warning signals
Power tool shuts down, capacity indicator flashes:
Battery pack is empty.

Change the battery pack.
Power tool shuts down, capacity indicator does
not flash: Power tool is overheating or has been
overloaded.

Apply a lesser load to power tool.

Allow power tool to cool down.

10 Service and maintenance

Customer service and repair only
through manufacturer or service
workshops: Please find the nearest
address at: www.festool.com/service
EKAT
Use only original Festool spare parts!
4
Order No. at: www.festool.com/service
5
3
2
1
Note the following information:
– Keep the ventilation slits on the machine free and
clean to ensure adequate cooling.
– Keep the contacts on the machine, charger and
battery pack clean.
70 - 100%
40 - 70%
15 - 40%
< 15%
Recommendation:
Charge battery pack
before further use.
Information on battery packs
– Store in a cool, dry place at a temperature be-
tween 5 °C and 25 °C.
– Protect battery packs from moisture, water and
heat.
– Do not leave flat battery packs in a charger dis-
connected from the mains power supply for lon-
ger than one month. Danger of deep discharge!
– If you intend to store li-ion battery packs for lon-
ger periods without use, you should charge them
to 40 % capacity (approx. 15 min charging time).
– To avoid short circuits the battery pack should be
stored in the packaging supplied.
11 Environment
Do not dispose of the device in house-
hold waste! Recycle devices, accesso-
ries and packaging. Observe applica-
ble national regulations.
EU only: In accordance with European
Directive on waste electrical and electronic equip-
ment and implementation in national law, used
electric power tools must be collected separately
and handed in for environmentally friendly recy-
cling.
Return used or faulty battery packs to your local
specialist retailer, Festool after-sales service or
nearest public waste management facility (observe
applicable regulations). Batteries must be dis-
charged on return. Battery packs will then be recy-
cled.
EU only: In accordance with the European Directive
on batteries and implementation in national law,
defective or used battery packs/batteries must be
collected separately and handed in for environmen-
tally friendly recycling.
Information on REACh: www.festool.com/reach
12 Transport
The lithium-ion batteries are subject to the require-
ments of the legislation on hazardous goods. A li-
ion battery pack alone falls below the applicable
limit value and certified as per UN manual ST/SG/
AC.10/11/rev. 3 part III, subsection 38.3. However,
dangerous goods regulations may apply when sev-
eral battery packs are transported For shipping by
third parties (e.g. air transport or freight forward-
ing company) special requirements with regard to
packaging and labelling must be observed.For the
preparation of the package an expert on hazardous
goods must be consulted. Please observe any fur-
ther national regulations.
TXS
GB
15