Warning Signals; Service And Maintenance; Environment; General Information - Festool TDC 18/4 Original Instructions Manual

10.2 Bit store [1-13]
CAUTION
Risk of injury from metal cuttings in the bit
store.
► Clean the bit store regularly and clear out
metal cuttings.

11 Warning signals

Warning signals occur and the power tool switches off in the following operating states:
Signal
Beeps once.
Beeps once.
Beeps twice.
Beeps continuously. -

12 Service and maintenance

WARNING
Risk of injury, electric shock
► Always remove the battery pack from the
power tool before performing any mainte­
nance or service work.
► All maintenance and repair work which re­
quires the motor housing to be opened
should always be carried out by an author­
ised service workshop.
Customer service and repairs must
only be carried out by the manufac­
turer or service workshops. Find the
nearest address at:
www.festool.co.uk/service
Always use original Festool spare
EKAT
4
parts. Order no. at:
www.festool.co.uk/service
5
3
2
1
To ensure constant air circulation, always keep
the cooling air openings in the motor housing
clean and free of blockages.
LED light
-
Flashes continuously. Kickback stop triggered.
-
Magnetic, for storing bits and bit holders.
Cause
Battery pack empty/incom­
patible.
Power tool overloaded.
When pressing the on/off
switch: Power tool has over­
heated.
Preset torque reached.
The power tool is faulty.
Keep the contacts on the power tool, charger
and battery pack clean.

13 Environment

Do not dispose of the device in the
household waste! Recycle devices, ac­
cessories and packaging. Observe appli­
cable national regulations.
EU only: In accordance with the European Di­
rective on waste electrical and electronic
equipment and implementation in national law,
used power tools must be collected separately
and handed in for environmentally friendly re­
cycling.
Information on REACH: www.festool.com/reach

14 General information

Imported into the UK by
Festool UK Ltd
1 Anglo Saxon Way
Bury St Edmunds
IP30 9XH
Great Britain
Action
Charge/change the battery
pack.
Reduce the load on the pow­
er tool.
Once it has cooled down, re­
start the power tool.
See section 10.1.
-
Contact the manufacturer to
rectify the fault.
English
19