System Configuration - NOVO NVO465-100 Operating Manual

Vacation Settings Mode
1. If screen is locked, press "
" to advance to VACATION MODE.
2. Press
"
3. Press and hold the
"
backwash and rinse along with the frequency are set while the valve is in vacation mode.

System Configuration

Valve Set Up
MODEL
BACKWASH
NVO465-75 5.0
NVO465-100 5.0
NVO465-150 5.0
NVO465-200 5.0
NVO465-300 5.0
NVO465-75C 5.0
NVO465-100C 5.0
Figure 13. Valve Set Up
Changing Valve Cycle Settings
1. If screen is locked, press "
2. Press and hold "
3. Press the "
DOWN" and advance to the BACKWASH menu option. Press " SET/REGEN" to edit the BACKWASH
minutes. Press "
accept the new value.
4. Press the "
DOWN" twice to advance to the RINSE menu option. Press " SET/REGEN" to edit the RINSE minutes.
Press " UP OR DOWN" arrows to change the RINSE minute values. Press " SET/REGEN" again to accept the new
or
value.
5. Press " MENU" to exit programming mode.
Automatic Bypass
MENU" for 3 seconds to unlock.
UP" for three seconds to enter the Vacation Settings Mode. In this mode the length of time for
PARAMETER
REGEN. DAYS
BACKWASH
RINSE
Figure 12. Vacation Mode Settings
VALVE CYCLE SETTINGS (MINUTES)
CLEAN WATER
BRINE/RINSE RINSE
50.0 5.0
50.0 5.0
50.0 5.0
50.0 5.0
50.0 5.0
50.0 5.0
50.0 5.0
MENU" for 3 seconds to unlock.
UP AND DOWN" for three seconds to enter Level Two Master Programming.
UP OR DOWN" arrows to change the BACKWASH minute values. Press " SET/REGEN" again to
or
The regeneration cycle lasts approximately 70 minutes, after which soft water service will be
restored. During regeneration, hard water is automatically bypassed for use in the household. Hot
water should be used as little as possible during this time to prevent hard water from filling the
water heater. This is why automatic regeneration is set for sometime during the night and manual
regenerations should be performed when little or no water will be used in the household.
DESCRIPTION
This value is the frequency of how often the unit should perform a
brief backwash and rinse.
This option controls the length of time in minutes for the unit to
briefly clean the bed by reversing the flow of water upwards through
the bed and out to the drain.
This option controls the length of time to give the tank a brief rinse
from the top to the bottom in order to remove any stale or stagnant
water from the tank.
PROBLEM WATER
BACKWASH BRINE/RINSE
10.0 50.0
10.0 50.0
10.0 50.0
10.0 50.0
10.0 50.0
10.0 50.0
10.0 50.0
DRAIN LINE
INJECTOR SIZE FLOW CONTROL
(GPM)
RINSE
5.0 #00 #1 (1.5)
5.0 #0 #2 (2.0)
5.0 #1 #3 (2.4)
5.0 #2 #4 (3.5)
5.0 #3 #7 (5.0)
5.0 #0 #2 (2.0)
5.0 #1 #3 (2.4)
BRINE LINE
FLOW CONTROL
(GPM)
0.70
0.70
0.70
0.70
0.70
0.70
0.70
10