Parts Names - Carrier 40MB*F Owner's Manual

in order to avoid electric shock or fire, make sure that an
earth leak detector is installed.
Be sure the air conditioner is grounded.
In order to avoid electric shock, make sure that the unit is
grounded and that the earth wire is not connected to the gas
or water pipe, lightning conductor or telephone earth wire.
in order to avoid injury, do not remove the fan guard of
the outdoor unit.
Do not operate the air conditioner with a wet hand.
An electric shock may occur.
Do not touch the heat exchanger fins.
The fins are sharp and touching them could result in injury.
Do not place items which might be damaged by moisture
under the indoor unit.
Condensation may form if the humidity is above 80%, the
drain outlet is blocked or the filter is polluted.
After a long use, check the unit stand and fitting for
damage.
If damaged, the unit may fall and result in injury.
To avoid oxygen deficiency, ventilate the room
sufficiently if equipment with a burner is used together
with the air conditioner.
Arrange the drain hose to ensure smooth drainage.
Poor drainage may cause water damage to the building,
furniture etc.
Never touch the internal parts of the controller.
Do not remove the front panel. Some internal parts are
dangerous to touch, and damage to the unit may occur.
Never expose little children, plants or animals directly to
the air flow.
injury to children, pets, or damage to plants may occur if
exposed to the unit's direct air flow.
Do not allow a child to mount the outdoor unit and avoid
placing objects on it.
Falling or tumbling of the unit may result in injury.
Do not operate the air conditioner when using a room
fumigation - type insecticide.
Failure to observe the safety precautions could cause the
chemicals to become deposited in the unit, which could
endanger the health of those who are hypersensitive to
chemicals.
Do not place appliances which produce open flames in
places exposed to the unit's air flow or under the indoor
unit.
Doing so may cause incomplete combuston or deformation of
the unit due to the heat.
Do not install the air conditioner any where flammable
gas may leak.
if the gas leaks out and remains near the air conditioner, a fire
may occur.
The appliance is not intended for use by young children
or infirm ed persons without supervision.
This appliance can be used by children aged from 8
years and above and persons with reduced physical,
sensory or mental capabilities or lack of experience and
knowledge if they have been given supervision or
instruction concerning use safe of the appliance and
understand the hazards involved. Children shall not play
with the appliance. Cleaning and user maintenance shall
not be performed by children without supervision.
This appliance is not intended for use by persons
(including children) with reduced physical, sensory or
mental capabilities, or lack of experience and
knowledge, unless they have been given supervision
or instruction concerning use of the appliance by a
person responsible for their safety.
Children should be supervised to ensure that they do not
play with the appliance.
if the supply cord is damaged, it must be replaced by the
manufacturer, its service agent or similarly qualified
persons in order to avoid a hazard.
Do not operate your air conditioner in a wet room such
as a bathroom or laundry room.
2. PARTS NAMES
The air conditioner consists of the indoor unit, the outdoor unit,
the connecting pipe and the remote controller. (Refer to Fig. 1)
[] Function indicators on indoor unit display panel
Infrared signal receiver
/_ Operation lamp
Timer indicator
PRE-DEF indicator(cooling and heating
type)
or fan only indicator(cooling only type)
--Temporary button
Display panel Fig. 2-1
This function is used to operate the unit temporarily in case you
misplace the remote controller or if batteries are exhausted.
Two modes including AUTO and FORCED COOL can be
selected through the TEMPORARY BUTTON on the display
panel. Once you push this button, the air conditioner runs in the
following order: AUTO, FORCED COOL,(COOLING TEST
HEATING TEST,)OFF, and back to AUTO.
AUTO
The OPERATION lamp is lit, and the air conditioner will run in
AUTO mode. The remote controller operation is enabled to
operate according to the received signal.
FORCED COOL
The air conditioner turns to AUTO after it is enforced to cool
with a LOW wind speed for 30 minutes. Once achieved, the
remote controller operation is disabled.
OFF
The OPERATION lamp turns off. The air conditioner is OFF
while the remote controller operation is enabled.
NOTE
This manual does not include Remote Controller
Operations, see the<<Remote Controller Owner's
manual>> packed with the unit for details.
5