Table of Contents
Advertisement
I
Parts of the Printer
(Rear View)
Paper support
(DE P.22)
Tractors
( DE P.22)
Top cover
Smoked plastic
cover(DE P.11)
Head Gap Lever
Adjusts the gap between the platen and the
printhead. The lever moves in increments of
0.0028 inch (0.07 mm).
"0,
Position
Used for
~
..... -2
~
...... ,
1 or 2
Thinner sheets
! :::::
3, 4, 5 and 6
Thick or multiple
v
'
sheets, envelopes
•
L -_ _ _ _ _ _ _ _
~
_ _
~
_ _ _ _
~
_ _
~
ACPo;w:'1e~rc~ordllll~JJ
(~'~
Paper Feed Selector
" LJ"
(Friction)
, []" (Tractor)
Single sheets
and envelopes
Fanfold paper
Serial interface cover
Serial No. Label
L - _ _ _ _
Centronics parallel interface
connector (DE P. 14, 94)
Nameplate
Frame ground
terminal (DE P. 14)
@
LF (FORM LENGTH) switch
Pressing this switch advances the paper one
line at a time. Holding this switch will
advance the paper continuously until the
switch is released. These functions are
active in the OFF LINE mode or when not
printing in the ON LINE mode.
In the FUNCTION mode, pressing the
switch advances the column for the
FORM LENGTH on the control table.
@)
FUNCTION switch
This switch allows you to enter and exit the
FUNCTION mode.
(j]
ON LINE/FUNCTION indicator
This indicator is lit when the printer is in the
ON LINE mode, and is out in the OFF LINE
mode. It blinks in the FUNCTION mode.
@ SUPER QUIET indicator
This indicator is lit when the printer is in the
SUPER QUIET mode.
@
POWER/PAPER OUT indicator
This indicator is lit when the power is on and
paper is installed. It blinks when paper is not
installed.
13
tD
!!l.
o
iil
-<
o
c:
~
~
Advertisement
Table of Contents
