Changhong Electric LE40D307 Operation Manual page 10

Connection and Setup
Setup Wizard
When the TV is initially powered on, a sequence of on-screen prompts will assist in
configuring basic settings. Press the SELECT button to start the guide. Press the ► button
to go to the next step. Press the ◄ button to return to the previous menu.
■ TV Mode: Press the ▲/▼ button to select Retail or Home.
■ Menu Language: Press the ▲/▼ button to select the desired OSD (On Screen Display)
language.
■ Time Zone: Press the ▲/▼ button to select your time zone.
■ Time Format: Press the ▲/▼ button to select 12-hour or 24-hour.
■ Source: Press the ▲/▼ button to select Air or Cable.
■ Auto Channel Scan: Scans and saves available programmes automatically.
NOTE:
• If the TV doesn't receive any channels, please check your aerial connection or the
country you selected, then try an auto tuning again.
• If the TV just receives some of the channels, it means the aerial's reception isn't good
enough and an antenna service is recommended.
Hotel Menu
Press the INPUT button to display the Source Menu, then press 2 0 1 2 to enter
into the Hotel Mode to adjust the relative settings.
Enable: Set the Hotel Enable On/Off by pressing the ◄/► buttons.
■
Hotel
• When Hotel Mode is On, the Channel function is locked.
■ On Source: Set the default signal source by pressing the ◄/► buttons. (The default
signal source will be displayed when the TV is turned on.)
■ On Channel: Set the default channel by pressing the ◄/► buttons. (The default
channel will be displayed when the TV is turned on.)
■ On Volume: Set the default volume by pressing the ◄/► buttons. (The default volume
is the volume when the TV is turned on. Remember the default volume should be less
than the maximum volume).
■ Volume Max.: Set max volume by pressing the◄/► buttons. When the max volume is
lower than the default volume, the max volume is the priority.
■ Logo Select: Both "Hotel Enable" and "Logo Select" are ON the Logo is displaying
when power on.
■ BACKUP: "BACKUP" means to write the TV data to USB device.
The function is supposed to be used when all the settings have been completed and
the "Hotel Enable" is ON.
■ RESTORE: "RESTORE" means to read data from USB device and write to local flash,
then the machine needs restart to initiate the parameters.
9