Table of Contents
Advertisement
Installation
Attaching the stand
For desktop use
1. Line the 4 posts on the top of the base up with the 4 holes on the
back of the phone.
2. Slide up into place until secure.
For wall mounting
1. Remove center screw from the base and separate the two parts.
2. Attach top part of base to the phone.
3. Mark and drill three 5/16" (7 mm) holes.
4. Insert plastic wall anchors (not included) into the holes. Insert and
tighten three screws (not included), leaving about 1/8" (2.5 mm)
exposed.
5. Slide the phone over the screws and ensure the phone is secure.
It may be necessary to remove the phone and tighten or loosen the
screws for secure mounting.
Installation
2
FortiFone™ QuickStart Guide
Advertisement
Table of Contents
