Advertisement
Flash-to-Pass
With the lever in the low beam position, pull
the lever
toward you to momentarily switch to high beams (to
signal that you
are
going to pass). If you have the
headlamps on, when you release the lever they will
return to low beams.
Windshield Wiper/Washer Lever
The lever on the right side
of the steering column
controls the windshield
wipers and washer.
Move the lever to the position you want:
OFF: The wipers are
off.
INT
Intermittent wiper operation (if your Prizm has
this). In light rain or snow, you might want to use this
position rather than continuous wiping. You can change
the time between wipes by turning the INT TIME band.
Turn the band toward
S
for a longer delay
or
toward F
for a shorter delay.
LO:
The wipers will
run
continuously at low speed.
HI: The wipers will run continuously at high speed.
MIST
(If you have mist-type wipers, the lever doesn't
have an INT position.) For a single wiping
cycle, push
the lever to MIST. Hold it there for a second, then let go.
The wipers will stop after one cycle. If you want more
cycles, hold the lever at MIST longer.
Be sure to clear ice and snow from the wiper blades
before using them. If they're frozen to the windshield,
carefully loosen or thaw them. If your blades do become
damaged, get new blades or blade inserts.
Heavy snow or ice can overload your wipers. A circuit
breaker will stop them until the motor cools. Clear away
snow or ice to prevent an overload.
2-27
Advertisement
